RIGOL Chapter 1 Quick Guide
1-22 M300 User’s Guide
Table 1-2). Pass the binding wires through the two groups of holes as pointed
out by the arrows in the figure below to fix the cable connected. Pay attention to
the channel or terminal connected to the cable to ensure that the signal
connected is correct.
Note:
For the connection method of each module and the corresponding terminal
block as well as the specification requirements of the connecting cable,
please log in RIGOL official website (www.rigol.com) to get more related
materials.
When using the mutliplexer module for measurement, make sure that both
the amplitude of the signal under measurement and the commom mode
voltage are no greater than the maximum input voltage of the module.
When the multiplexer module is used to measure an object with high-power
output ability (such as battery and power supply), to avoid damaging the
relay, you are recommended to connect a fuse in serial when making
connections (as shown in the figure below).
01
H
L
H
L
...
H
L
H
L
...
H
L
16
17
32
Channel
Switches
Terminal
Box: TB32
H
L
01
H
L
32
.
.
.
78-Pin
Interface
M300
Mainframe
DMM Module
MC3065
+
V
measured
V
measured
Fuse
Fuse
To Next Page
Loading...