Rinnai 43 Multi Split Type AC
WIRING
BEFORE PERFORMING ANY
ELECTRICAL WORK, READ
THESE REGULATIONS
1. All wiring must comply with local and national
electrical codes, regulations and must be
installed by a licensed electrician.
2. All electrical connections must be made
according to the Electrical Connection Diagram
located on the panels of the indoor and outdoor
units.
3. If there is a serious safety issue with the power
supply, stop work immediately. Explain your
reasoning to the client, and refuse to install the
unit until the safety issue is properly resolved.
4. Power voltage should be within 90-110% of
rated voltage. Insucient power supply can
cause malfunction, electrical shock, or re.
5.
6.
If connecting power to fixed wiring, a surge
protector and main power switch should be
installed.
If connecting power to xed wiring, a switch
or circuit breaker that disconnects all poles and
has a contact separation of at least 3mm must
be incorporated in the fixed wiring. The
qualied technician must use an approved
circuit breaker or switch.
13.
Make sure that you do not cross your
electrical wiring with your signal wiring.
This may cause distortion and
interference.
14.
The unit must be connected to the
main outlet. Normally, the power supply
must have a impedance of 32 ohms.
15.
No other equipment should be
connected to the same power circuit.
16.
Connect the outdoor wires before
connecting the indoor wires.
9.
10.
11.
12.
Every wire must be rmly connected. Loose
wiring can cause the terminal to overheat,
resulting in product malfunction and possible re.
Do not let wires touch or rest against refrigerant
tubing, the compressor, or any moving parts
within the unit.
If the unit has an auxiliary electric heater, it must
be installed at least 1 metre away from any
combustible materials.
To avoid getting an electric shock, never touch
the electrical components soon after the power
supply has been turned o. After turning o
the power, always wait 10 minutes or more
before you touch the electrical components.
WARNING
BEFORE PERFORMING ANY
ELECTRICAL OR WIRING WORK,
TURN OFF THE MAIN POWER TO
THE SYSTEM.
7.
Only connect the unit to an individual branch
cir
cuit outlet. Do not connect another
appliance to that outlet.
8. Make sure to properly earth the air conditioner.
Isolation switch
(A)
(purchased seperately)
Outdoor unit power wires
Indoor & Outdoor
connective wires
(purchased seperately)
Outdoor unit
Indoor unit
To Next Page
Loading...
Need help?
General
