Reference Manual V1.19 Software Versions 4.xx
Page 62 003R-682-119
15.2.11. NET.HLD
The <NET.HOLD> key is used to hold the current net weight value when the function key is
pressed. It will adjust the tare value when the key is pressed again to keep the net weight at
the same value as when it was held.
15.2.12. MED.HLD
The <MED.HOLD> key is used to hold the current gross and net weight values when the
function key is pressed. It will adjust the zero value when the key is pressed again to keep
the gross and net weight values the same as when they were held.
15.2.13. MVV
The <MVV> key is used to toggle between displaying the load cell mV/V value and the
weight.
Press and hold the < SET.PT > key to edit the target threshold associated with output1.
The “SetPt.1” annunciator appears briefly on the display before editing mode is entered
to indicate that the output 1 threshold is being edited.
Press the <OK> key to enter the output 1 threshold. Change the threshold to the required
value using the <SEL> and <EDT> keys.
Press the <OK> key to store the new output 1 threshold. When the process is complete
the display will move on to editing the output2 threshold.
The “SetPt.2” annunciator appears briefly on the display before editing mode is entered to
indicate that the output 2 threshold is being edited.
Press the <OK> key to enter the output 2 threshold. Change the threshold to the required
value using the <SEL> and <EDT> keys.
Press the <OK> key to store the new output 2 threshold. When the process is complete
the indicator will revert to the condition it held prior to the initial pressing of the < SET.PT >
key.
To Next Page
Loading...
