Arming and Disarming
Page 27
Under no circumstances must the duress code be used haphazardly or
without reason. Central stations, along with police departments, treat
duress codes very seriously and take immediate action.
Disabling a Fire Alarm (Switch Auxiliary)
Unsetting the fire alarm interrupts the power supplied to the system's smoke detector(s)
for a predetermined interval, thus resetting and "readying" them for subsequent alarms.
Note:
You may need to perform this procedure several times in order to
prevent the smoke detector(s) from re-detecting any remaining smoke.
To disable a fire alarm
1. Press and enter your grand master code followed by .
2. Using the arrow keys, scroll to the option Activities and press .
3. Scroll to Advanced and press .
4. Scroll to Switch AUX and press .
5. The fire alarm is disabled for a predefined amount of time.
Additional Arm/Disarm Capabilities
Automatic Arm/Disarm
The LightSYS™2 has the ability to define automatic system arming at a predefined time of
a day. An Arm/Disarm program automatically arms and disarms the system during your
required time intervals. When defining the automatic arming/disarming program, you
need to define the following parameters: Partition, Arming Mode (Away/Stay), Time, and
Label.
Arm /Disarm from your Wireless Keyfob
The system can be armed using a wireless keyfob (If equipped with a wireless module
expansion). For detailed information regarding the keyfob operation consult with your
installer .
Remote Arm/Disarm Using a Phone
If your LightSYS™2 is equipped with the voice module you can perform
arming/disarming operations and operate the system from a remote touch-tone phone by
initiating a telephone call to or from the system and interacting with voice menus that
guide you through your required remote operation. For detailed information refer to the
5IN1545 LightSYS Voice Module Instructions.
To Next Page
Loading...
