Risco lightsys 2 - Appendix A - System Troubles

Appendix A – System Troubles
The following table lists possible trouble conditions, their descriptions, and recommended
responses.
Trouble Description Response
Low Battery The capacity of the battery is low or
missing and needs to be recharged or
replaced. Replace rechargeable batteries
according to the battery manufacturer.
Contact your dealer.
Loss of AC Power The commercial power has been
interrupted; the system will continue to
operate on its standby battery as long as
possible. Loss of AC Power will be
displayed on the LCD.
Check the connection of the
panel's transformer to its AC
source. Be sure that power
has not been interrupted or
switched off.
Auxiliary Failure The auxiliary power, used to supply
electric current to designated devices
(e.g. motion detectors, keypads, and
smoke detectors), has failed (either form
panel or the optional power supply
module(s)) .
Contact your dealer.
False Code
Trouble
If enabled by your dealer, your system
will report a false code as a trouble.
Once the trouble has been
displayed (LCD keypad
only), it will automatically
be removed from the
system.
Phone Line
Failure
The telephone line used for monitoring
station communication is either
disconnected or inoperative.
If all premises telephones
are operating properly,
contact your security dealer.
Bus Failure A fault has been detected in the wiring
supporting system peripherals. The
trouble indicates the device with the
communication trouble.
Contact your dealer.
Clock Not Set The system's clock has lost track of the
time and/or date.
Set the system's time and
date.