Arming and Disarming
Page 23
( ).
For example, to arm group C, enter:
[Code] [ for two seconds] [Partition No] [ for two seconds].
3. To arm another group, repeat above steps .
Note:
If your system supports Quick Arming, press the function key for two
seconds corresponding to the group(s) you want to arm. The selected groups
are armed.
Arming With Troubles in the System
If required, and defined by your installer, all troubles in the system may require
confirmation to enable the arming operation.
When trying to arm the system with troubles, the display will show the system troubles.
Scroll through the list of troubles using the key. At the end of the list the following
question will appear: « Override Trouble? » Use the key to toggle the option to Y and
press .
Keyswitch Arming
If your system is equipped with a special keyswitch, it can, with the twist of a key, be
toggled through arm (away) and disarm modes.
Arming in Blank Display Mode
To perform arming while the system is in blank display mode:
1. Release the keypad by pressing [CODE] +
2. Within 2 minutes time press:
For away arming
For stay arming
Disarming your system
Disarming your system causes the detectors not to trigger an alarm when violated.
Disarming deactivates the partitions assigned to the specified user code.
You can disarm your system by code, for which you need to use your user code or a
proximity tag.
,
,
,
To Next Page
Loading...
