Arming and Disarming
Page 24
When you enter the premises, the entry delay count-down period begins. You must disarm
the system within the entry delay period to prevent it from triggering an alarm. The
disarming operation will be followed by a local message announcement (if defined).
LightSYS™2 disarming varieties include the following:
Full Disarming
1. If outside the premises, open an "entry" door. The keypad(s) beeps, indicating that the
entry delay time period has begun.
2. Before the entry delay time period expires, enter your user code followed by or
present the proximity tag.
Note:
1. If you make a mistake entering your user code, the keypad produces three
short beeps. If so, simply re-enter the above sequence correctly.
2. If defined by your installer, system sirens sounding two siren chirps indicate
that the system is disarmed.
Partition Disarming
Partition disarming enables you to disarm individual partitions within an armed system.
To disarm specific partitions:
1. Enter user code followed by or present the proximity tag.
2. Select the partition number (1–4) OR- to disarm all partitions at once, select 0.
3. Press to confirm. A confirmation message will be displayed for several seconds.
4. Repeat the above steps to disarm other partitions. Examples:
1. To disarm partition 3 with code 1234: 1-2-3-4 3 .
• To disarm ALL partitions: 1-2-3-4 0 .
• To disarm partitions 3 and 4 with a tag: 1-2-3-4 3 4 .
Disarming after an Alarm
If an alarm has occurred, it will be indicated by the keypad. Once the cause of the alarm
has been established the system must be reset.
To disarm the system after an alarm:
1. If outside the premises, open an "entry" door. The keypad(s) beeps, indicating that the
entry delay period has begun.
To Next Page
Loading...
