Arming and Disarming
Page 25
2. Observe the keypad. If the icon is flashing, and the display shows the activated
partition, an alarm activation has occurred. Pressing the key will show the
activated partition and zone.
3. Hold the tag close to the keypad's keys OR enter your user code and press . If an
alarm occurred:
a) The icon will flash
b) The sirens will sound four siren chirps, indicating that an alarm occurred in the
system.
c) If your system is equipped with the voice module, an announcement message
will be broadcast: "Alarm occurred in the system".
4. Scroll through the list of alarm zones. To exit the alarm memory mode before the
timeout has expired, press (which will clear the alarm memory) or (which
will not clear the alarm memory)
5. If required, proceed to “Resetting after an alarm” (see below).
Note:
If an alarm occurred in the system, it is recommended to leave the premises. Only after
police investigation should you consider that the burglar is no longer on your premises
and you can re-enter. In special cases (if programmed by your installer) arming the system
after an alarm might require a technician code. On the LCD, a Not ready - technician reset
message may appear. For more information, consult with your installer.
Important:
If the alarm was caused by a tripped smoke detector(s), the keypad's Fire ( )
indicator will remain lit, providing an indication that the fire system must be
reset before it will be capable of detecting subsequent infractions. Furthermore,
until it is reset, you will be prevented from setting your system.
To reset a smoke detector, press > User Code > > Activities
> > Advanced > > Switch Auxiliary > .
Note: You may need to perform this procedure several times in order to prevent
the smoke detector(s) from re-detecting any remaining smoke
Press to exit the user functions mode.
To Next Page
Loading...
