User Functions and Settings
Page 40
Parking Control with LightSYS™2 Gate Control Keyfobs
If your system is equipped with a wireless expander it can support up to 200 keyfobs that
can be used for controlling two outputs for gate and parking control. These keyfobs are
additional to the keyfobs that can be used to control the security applications of the
system. Each keyfob had a dedicated button to support each output.
The grand master or the installer can control the management of these keyfobs
Notes:
The following procedures are relevant only for stand-alone keyfobs. The keyfobs that
control the security system can be defined and programmed only by your installer. Your
installer must define the outputs and the way they will operate so you can perform the
following procedures.
Assign New Keyfob
1. Press and enter Grand Master code followed by .
2. Using the arrow keys, scroll to the option Stand Alone KF and press .
3. Select the receiver that you want to assign the keyfob to and press .
4. Using the arrow keys, scroll to the New Keyfob option and press .
5. Press the key to start the keyfob registration mode.
6. Press the keyfob key for 3 seconds.
7. Repeat step 6 for additional keyfobs. When finished press to exit registration
mode.
Delete a keyfob
1. Follow steps 1-3 of the previous procedure (See Assign New Keyfob) 2.
Using the arrow keys, scroll to the Delete Keyfob option and press
.
3. Press the key to start the keyfob erase mode.
4. Press the keyfob key for 3 seconds.
5. Repeat above steps for additional keyfobs. When finished press to exit Erase
mode
Delete All keyfobs
1. Follow steps 1-3 of the previous procedure (See Assign New Keyfob)
2. Using the arrow keys, scroll to the Delete All Keyfobs option and press .
3. Use the key to toggle to Y and press .
To Next Page
Loading...
