Risco lightsys 2 - Setting and Changing System Time and Date; Setting Follow Me Destinations

User Functions and Settings
Page 34
3. Toggle Y or N by using the key and then pressing . If you select Y, the
following confirmation message is displayed: USER XX: TAG DELETED
To delete a proximity tag by user tag:
1. Press and enter your code followed by .
2. Using the arrow keys, scroll to the option Codes/Tags and press .
3. Scroll to Del By Tag and press .
4. Within 10 seconds, approach the proximity tag at a distance of 4 cm. from the front of
the keypad bottom. If the proximity tag was deleted, the following confirmation
message is displayed: USER TAG XX DELETED.
If the system does not recognize the proximity tag, the following message is
displayed: TAG NOT DEFINED IN MEMORY.
Setting and Changing System Time and Date
The correct time and date must be set to ensure proper operation of LightSYS™2.
To set/change the system time:
1. Press and enter grand master code followed by .
2. Using the arrow keys, scroll to the option Clock and press .
3. The display will show Time and Date. Press .
4. Enter the correct time in 24-hour format and date. For entering the date use the
keys to move the cursor and the key to toggle among the choices.
5. Press to save your settings.
Setting Follow Me Destinations
In the case of an alarm or event, the system can initiate a phone call to a designated
telephone, send an SMS/email and employ unique tones or messages to express the active
event or perform push notification to your smart phone application. Consult your
installer for configuring event reporting to a Follow Me destination.
Note:
When the LightSYS™2 is connected in cloud mode (depending on system settings) the
system may only be able to send emails or push notification to Smartphone applications.
To enter/edit a Follow Me destination:
/