User Functions and Settings
Page 33
To add a new proximity tag:
1. Press and enter your code followed by .
2. Using the arrow keys, scroll to the option Codes/Tags and press .
3. Scroll to Define and press .
4. Select the user to which you want to assign the proximity tag and press . Each
proximity tag can be assigned to only one user.
Note:
A display of (****) indicates that a user has already been assigned to a specific
proximity tag.
5. Scroll to (Re)write Tag. Press .
Within 10 seconds, approach the proximity tag at a distance of 4 cm. from the front of
the keypad bottom. The keypad automatically reads the proximity tag and saves it
into the system's memory.
Once the proximity tag has been successfully recorded, a long confirmation beep
sounds, and a confirmation message is displayed.
If the proximity tag is already stored in the system's memory, the following message
is displayed:
USER TAG ALREADY IN MEMORY
Notes:
• Once a proximity tag is recognized, it will be functional from all keypads.
• The programmed proximity tag has the same permissions that are defined
for the specified user code.
• If a user is defined as having the Cleaner security level, then the proximity
tag can operate only if a security code was previously defined for that user.
Deleting a Proximity Tag
Deleting proximity tags can be performed in either of two manners:
By user number: Use this option to
delete a tag for which the user is known
By tag: Use this option to delete a tag for which the user is not known
To delete a proximity tag by user serial number:
1. Follow steps 1-4 of the previous procedure (See Adding a new proximity Tag)
2. Scroll to Delete Tag and press . The following question appears: Delete,
Are you sure?
To Next Page
Loading...
