User Functions and Settings
Page 30
GRAND
MASTER
All operations for all partitions. There is only one grand
master code in the system, and it is designated as user index
number 00.
This code can be changed by the installer or the grand master.
Notes:
Your LightSYS™2 was given a grand master code of 1-2-3-4
during manufacturing. RISCO advises that you modify this code
to one that is unique and personalized as herein described,
unless your alarm company has already done so.
MASTER All operations but only for designated partitions. The user
holding the master code can change the master code and the
codes of all authority levels lower than master. LightSYS™2
supports an unlimited numbers of master codes.
USER Only basic operations for one or more partitions.
DURESS Like USER except that when disarming the system a duress
alarm message is sent to the monitoring station.
ARM ONLY Arming one or more partitions.
Arm only codes are useful for
workers who arrive when the premises are already open but,
because they are the last to leave, are given the responsibility to
close and secure the premises at the day’s close.
CLEANER Used only for one-time arming and disarming, after which the
code is automatically erased and should be redefined. This code
is typically used residentially for maids, home attendants, and
repairmen who must enter the premises before the owner(s)
arrive.
UNBYPASS Basic operations to one or more partitions without the ability to
GUARD Typically used to enable a guard to disarm the system for a
predefined amount of time. After this period, the system is
automatically armed again.
UO ONLY
Typically used to enable the operation of a device controlled by a
utility output (UO) (for example, a door). These codes are used
only to operate a utility output.
To Next Page
Loading...
