3.2.11 Setup Quit
This screen allows the user to exit the setup menu.
Pressing the “ ” key advances to the System Parameter Selection (see
Section 3.2.1) screen and pressing the “ ” key advances to the “Factory
Reset” (see Section 3.2.10) menu.
Pressing “ ” key quits from the Setup menu and advance to
measurement screen at which the setup screen was accessed.
Factory Reset Selection Screen
Pressing “ ” or “ ” key allows the user to select between “YES” or “no”.
YES : Allow Factory Reset
no : Don’t allow Factory Reset
Pressing “ ” accepts the selection and if the selection is “YES”,advances
to “Pls Wait” screen followed by the “Sure” screen of “Factory Reset
Screen” (see Section 3.2.10). If the selection is “no”, then “Pls Wait” screen
does not appear.
3.2.10.1 Factory Reset Selection
This screen allows the user to erase all data from the meter and set all
setup parameters to their default values.
Pressing the “ ” key advances to the “Sure” (confirmation) screen which
displays a “no”.
Pressing “ ” or “ ” key advances to Factory Reset Menu(see Section
3.2.10).
Whereas pressing “ ” key advances to the Factory Reset selection
screen.
XXXXXXXX
78
To Next Page
Loading...