Riso 9630 - Warning

1-6
ComColor GD Series Troubleshooting Guide
<W000-0000>Warning
These warning messages are displayed when there is no more paper, the output tray is full, a peripheral device is
not connected, or there is another problem.
The stacking tray of High
Capacity Stacker is not set. Set
the stacking tray.
The stacking tray is not set on the high capacity stacker.
After setting the stacking tray on the carriage, return this to the high
capacity stacker.
Message Action to Take
Set paper.
The paper specified for the job is not loaded in the tray available for auto
selection.
Load the corresponding type and size of paper in the tray available for
auto selection. Otherwise, touch [Change Tray] and change [Paper
Selection] to a setting other than [Auto], or enable [Auto Selection] for a
tray loaded with the specified paper.
Auto tray selection is not
available. Select a paper tray,
and press the Start key.
Auto selection is not performed if it is not enabled for any of the trays,
even when paper tray selection is set to [Auto]. Touch [Paper Selection]
and select the tray, or enable [Auto Selection] for the required tray.
The paper size may not be
correct. Check the standard tray
paper guide, tray, or paper size
setting.
The size of paper specified for the job is not loaded. Load the specified
size of paper. Otherwise, touch [Change Tray] and enable [Auto
Selection] for a tray loaded with the specified paper.
The Standard Tray (Feed Tray 1,
Feed Tray 2, Feed Tray 3) is not
available. You can use another
tray to continue printing.
A problem has occurred with the standard tray (or with feed tray 1, feed
tray 2, or feed tray 3).
Touch [Change Tray] and specify a different paper tray.
Job name:
This paper size cannot be output
to the specified tray. Change the
output tray or paper size. (The
job was deleted.)
Touch [Close], change the settings, and send the data again. For more
information on the paper sizes that can be used with each tray, see
"Printing Paper" in the "Safety Information".
This paper size cannot be output
to the current output tray. Check
the orientation or settings of the
set paper.
Touch [Close], change the settings, and send the data again.
For more information on the paper sizes that can be used with the output
tray, see "Printing Paper" in the "Safety Information".
This paper size cannot be output
with offset output. Check the
orientation or settings of the set
paper.
Touch [Close], change the settings, and send the data again. For more
information on the paper that can be used with offset output, see "Printing
Paper" in the "Safety Information".
There is no tray to which paper
can be output.
Remove paper.
The paper output to each tray exceeds the maximum load capacity.
Remove paper.
Message Action to Take