DAILY LIVING
Doc No: 21906540-RSAD Rev: 02 Copyright © Roadtrek Motorhomes Inc. 2010 B-4
SLEEPING FACILITIES:
REAR TWIN BEDS
To convert the dinette into twin beds:
1. Remove the table and leg from its receptacle and
place the table under the driver side seat cushion
and store the table leg.
2. Place both back rest cushions on the floor vertically
up against the seat base boxes or store if desired.
3. Pull each seat cushion 3", (8 cm) from the wall to
provide additional elbow room while sleeping.
4. Night table can be removed, (see Picture B-P7)
and stored if desired.
To convert back to a dinette, perform these steps in
reverse order.
Picture B-P8: Placement of the cushions for
Twin beds (regular dinette).
Picture B-P9: Dinette table and bed support for King
size bed, (stored position).
Picture B-P7: Wing bolts attaching the night table,
are accessed from the sides of the night table as
illustrated above.
Wing
bolts
Dinette
table
Bed
support
To Next Page
Loading...
