EasyManua.ls Logo

Roadtrek Sprinter - Smoke Detector Operation

Roadtrek Sprinter
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SMOKE DETECTOR:
Your vehicle is equipped with a smoke detection device for
your protection, (see Picture F-P3).
See “Floor Plan & Appliance Location for the smoke detector
location.
This device should be tested after each time your vehicle
has been in storage, before each use, and at least once each
week during your vehicles use.
NOTE: Upon delivery of your vehicle from the factory,
the smoke detector is inoperative due to the fact that the
battery has been reversed to prevent batery drainage.
Before operation, reverse the battery to the proper position
and test the operation of the smoke detector by pressing
the test button located on the front of the smoke detector.
To gain access the smoke detector battery, turn the smoke detector 1/4 turn counter clock wise and the detector
will remove from the smoke detector mounting base.
Be sure the smoke detector is operating while using your vehicle.
Do not block air circulation in the area where the smokedetector is located.
See Manufacturers Owners Manual for operating instructions.
NOTE: Cleaning products, sealants, and some adhesives may contaminate safety detectors. All of the detectors
should be covered when using cleaning chemicals or working on the vehicles interior.
PROPANE & SAFETY SYSTEM
Doc No: 21906540-RSAD Rev: 02 Copyright © Roadtrek Motorhomes Inc. 2010 F-3
Picture F-P3: Smoke detector.

Table of Contents

Related product manuals