Unit assembly
© robatherm 41
Workflow at the separation point
1. Dismantle transport lugs (B) and
screws.
Fig. 52: Disassemble transport lugs
2. Close holes from above with plugs
(gray) or plugs (gray), depending
on casing construction.
3. Close holes from below with plugs
(white), depending on casing
construction.
Fig. 53: Sealing holes
Roofing membranes and drip edges (D)
next to the separation point (C) must be
clean.
4. Clean soiled roofing membranes
and drip edges (D) using a damp
cloth.
Fig. 54: Cleaning
Roofing membranes next to the
separation point (C) must be dry.
5. Dry wet roofing membranes and
drip edges (D) using hot air.
Fig. 55: Drying
To Next Page
Loading...