30
Note: In case that setup of DMC has been created, the following message will appear:
Select the option "Load" if you want to load existing setup and modied it.
Touch the "Next" button.
Three xtures are selected for the multi device operation.
3. The following message will appear on the screen:
Select desired reference device from devices intended for the multi device control (the reference device should
be a device with a camera /BMFL FollowSpot with camera or RoboSpot Motion camera)/ and should not be
placed on the edge of xtures row, optimal position is in the middle of xtures /if it is possible/, in this case it
is the BMFL FollowSpot).
The pan/tilt position of the reference device is directly controlled by means of the RoboSpot handles.
The pan/tilt positions of remaining devices in the multi device control are calculated in relation to the reference
device.
Touch the "Next" button.
4.The Following message will appear on the screen:
Working area for the follow spot operation
Exit -cancels MDC setup
Next - goes to next step
Prev - goes to previous step
To Next Page
Loading...
