Robe RoboSpot - Settings

38
6.8 Settings
The menu allows you to set the behaviour of the RoboSpot according to your needs.
System Test - the menu allows you to test jog-wheels, faders and pan/tilt movement of the RoboSpot.
Ethernet Settings - the menu allows you to set the RoboSpot for the Ethernet operation
Ethernet Mode
Artnet - Fixture receives Artnet protocol
gMAI - Fixture receives MANet I protocol
gMA2 - Fixture receives MANet 2 protocol
sACN - Fixture receives sACN protocol
IP Address/Net Mask - select this menu to set IP address. IP address is the Internet protocol
address.The IP uniquely identies any node (xture) on a network.
There cannot be 2 xtures with the same IP address on the network!
Default IP Address -Preset IP address, you can set up only rst byte of IP address
(2 or 10) e.g. 002.019.052.086.
Custom IP Address - The option enables to set up all bytes of IP address.
Net Mask - The option enables to set up all bytes of Net Mask.
ArtNet Universe - use this item to set a Universe (0-255). The Universe is a single DMX
512 frame of 512 channels.
MANet Settings - use this menu to set parameters for MANet operation.
MANet Universe I/II - The value of this item can be set in range 1-256.
MANet Session ID - The value of this item can be set in range 1-32.
sACN Settings - use this menu to set parameters for sACN operation.
sACN Universe - The value of this item can be set in range 1-32000.
sACN Priority - The value of this item can be set in range 0-255.
Discovery Settings - the menu item allows you to set a behaviour of the RoboSpot during RDM discovery
process (menu item RDM Discovery) and after switching the RoboSpot on.
Auto - the RoboSpot searches connected devices after each switching it on and does not save
the list of discovered devices. Also If the option RDM Discovery is run, the list of discovered devices
is not saved.
Manual - the RoboSpot searches connected devices and save the list of discovered devices.
When the RoboSpot is switched on, the saved list of discovered devices will be load to the RoboSpot
and (even in case that xtures are not be connected to RoboSpot) the RoboSpot will not run
the discovery procedure.
Controls invert - the menu item allows you to invert pan/tilt and faders of the RoboSpot.
Default settings of faders: fader down-minimum (0 DMX), fader up-maximum (255 DMX).
Faders Switch - swaps functions of faders.
Camera Rotation - the function rotates a camera picture on the monitor 180 degrees from the current orientation.
Camera Zoom invert - the function inverts a camera zoom.
Password Settings - the menu item allows you to change the password or switch it o󰀨 at a current user preset.
The password applies to the FollowSpot Controller as well as the RoboSpot screen and also to all user presets.
You cannot have a di󰀨erent password for each user preset.
Change password - use this option to change password. Default (factory) password is 5242.
Protect with Password - If this function is on, the password is required at entry the menu at the current
user preset.
Note: both menu items stated above require inserting of password to enter them even the password is
set o󰀨 ! You have to remember the last set password!