RS-LiDAR-32 User Manual
2. An Open File dialog will pop up. Navigate to a pcap file, select it, and click the Open button.
Figure C-7: Select the PCAP file.
3. The Sensor Configuration dialog will pop-up. Select your sensor configuration folder and click OK.
4. Press Play to replay/pause the data stream. Use the Scrub slider tool (it looks like an old-fashioned
volume slider) to move back and forth through the data frames. Both controls are in the same toolbar as
the Record button (Figure C-8).
Figure C-8: RSView Play Button.
5. To take a closer look at some data, scrub to an interesting frame and click the Spreadsheet button
(Figure C-9). A sidebar of tabular data is displayed to the right of the rendered frame, containing all data
points in the frame.
Figure C-9: RSView Spreadsheet Tool.
To Next Page
Loading...
