RS-LiDAR-32 User Manual
Figure C-16: Data Port Setting.
C.9 Firmware Online Update
Before begin firmware online update, we need make sure the RS-LiDAR-32 is working normally, that
means we can view the point cloud and get LiDAR information in RSVIEW.
Click Tools > Online Update, we can select the top board firmware update and bottom board firmware
update as shown in Figure C-18.
Figure C-17: Online Update.
For example, when we choose “Bottom Board Update”, we need direct to choose the .rpd firmware file
for update, and then click Open to begin the online update process. The online update process would
take some time, if the firmware update successfully, it will show “Online Update Successful”.
Note: The Config Update option is not available.
To Next Page
Loading...
