28 / 44
3 STORAGE
3.1 Handling
Warning : Do not remove the arrangement to lock motor brackets during handling.
To handle the ROBOX DV use the wooden pallet as indicated in the figure 6 below, the weight is indicated at page 41
Fig. 5
Warning : If it is not possibile to use the fork lift contact ROBUSCHI
Transport ROBOX DV in a closed mean protected against the atmospheric agents, in case of sea transport protect ROBOX DV by the sacco
barrier with igroscopic salts
During transport fix the pallet of the pump to the base of transport devices using belts in order to avoid any possible damage to the pump
Warning : Remove any free body from the transport device in order to avoid any possible
3.2 Unpacking
Check always the correspondence between documents and materials and the presence of eventual damages due to transport.
Warning : Please refer to ROBUSCHI any damage to evaluate the safety conditions of ROBOX DV
Warning : Remove with care the packing and clearing all the dangerous elements (nails, splits, etc…)
3.3 Preservation
Keep ROBOX DV in a place protected against solar radiation and at following climatic conditions :
Temperature from –20 °C to 40 °C
Relative humidity from 10 % to 80 %
If different climatic conditions are forecast contact ROBUSCHI.
Warning : If, during storage, the climatic conditions overcame the indicated limits check the pump
clearances, the coupling alignment and the screws tightening.
Warning : Do not preserve ROBOX DV in atmosphere with any substance also feebly corrosive
Warning : Preserve ROBOX DV onto ground without any weight onto it
Renew preservation every 6 months or more frequently if humidity is higher than 80% using anti-rust oil
Parts
AGIP ESSO SHELL
Shiny external parts Rustia 27 Rust Ban 397 V-Produkt 9703
Rotors Casing Bearing
Gear
Rustia C 100 Antiruggine MZ 110 Ensis Motor Oil 20
Warning : Use anti-rust oil with fire point over 200 °C
Warning : Dispose the used anti-rust oil in accordance with local regulations
To Next Page
Loading...