96 Rockwell Automation Publication 1769-UM021I-EN-P - May 2018
Chapter 5 Complete Software Tasks Required at CompactLogix 5370 Controller Installation
To disable BOOTP/DHCP from the Studio 5000 environment, perform the
following:
1. Start the application.
2. Open the project.
3. Right-click on the controller and choose Properties.
4. On the Controller Properties dialog box, click the Internet Protocol tab.
5. Click Manually configure IP settings.
6. Click OK.
7. When prompted to confirm the IP address setting, click Yes.
To Next Page
Loading...
