Rockwell Commander 112 - Page 44

ROCKWELL
COMMANDER
112/B/TC /TCA
MAINTENANCE MANUAL
SECTION n
SERVICING
AND INSPECTION
the cotter pins securing the pivot pins in the center of
the hinges (see Figure 2-10). Support the door as-
sembly while the pivot pins are being removed to pre-
vent damage to the lower edge of the door or hinge
points.
Cabin Door Installation
The cabin door installation is the reverse of the re-
moval procedures.
Cabin Door Adjustment
Cabin door adjustment can be made by repositioning
the upper (overhead) door latch striker hook as neces-
sary to provide a snug fit between the door and fuse-
lage skin. To adjust striker hook remove striker
plate and spacer then rotate hook to desired position.
Change 2
Replace spacer and striker plate. The weather- strip
around the perimeter of the interior door surface
should be replaced as necessary to maintain a weather
seal and proper fit between door and door frame.
Cabin Door Handle Removal
To remove the door handle from the door, proceed
as follows:
a. Remove door upholstery.
b. Remove outside handle by removing retaining
screws.
c. Disconnect door handle adjustment cable at the
center of door by removing cotter pin and clevis pin
holding two adjustment cables together.
d. Remove retaining screw s and pull inside handle
straight out.
2-20A/2-20B
Copyright Commander Owners Group 2013 All Rights Reserved
**unofficial copy**