Rockwell Commander 112 - Page 9

INTRODUCTION
MAINTENANCE MANUAL
ROCKWELL
COMMANDER
112/B/TC/TCA
1. Remove and dispose of all pages in the manual
except the tab dividers and insert the new
pages in each section.
IDENTIFICA TION OF CHANGED MATERIAL
Changed text will be identified by a black vertical
line along the outside margin of the page, opposite
revised or added material. Changed illustrations
will have symbols within the border of the illustration
to indicate minor changes. Major changes requiring
complete redrawing of an illustration will be indicated
by a black vertical line along the outside margin of
the page opposite the illustration.
Revisions of text and illustrations will not have any
change
markings as they are treated as new pages in
a new manual.
WARNINGS, CAUTIONS, AND NOTES
The following definitions apply to "WARNINGS",
"CAUTIONS",
and "NOTES" found throughout the
manual.
ii
I WARNING I
An operating procedure, practice, or
condition, etc., which may result in
injury or death, if not carefully observed
or followed.
An
operating procedure, practice, or
condition, etc., which may result in
damage to equipment, if not carefully
observed or followed.
NOTI
An operating procedure, practice, or
condition, etc., which is essential to
emphasize.
WORDING
The concept of word usage and intended meaning
which has been used in preparing this manual is as
follows:
"Shall" has been used only when application of a pro-
cedure is mandatory.
"Should" has been used only when application of a
procedure is recommended.
"May" and "need not" have been used only when appli-
cation of a procedure is optional.
'Will" has been used only to indicate futurity, never
to indicate any degree of requirement for application
of a procedure.
Copyright Commander Owners Group 2013 All Rights Reserved
**unofficial copy**