Rohde & Schwarz FSW43 - Emulating Other Instruments Commands; Setting up Instrument Emulation

Remote Commands
R&S
®
FSW
1049User Manual 1173.9411.02 ─ 19
SYSTem:CLOGging <State>
This command turns logging of remote commands on and off.
Parameters:
<State> ON
Writes all remote commands that have been sent to a file.
The destination is C:
\R_S\instr\ScpiLogging\ScpiLog.txt.
OFF
*RST: OFF
Manual operation: See "I/O Logging" on page 652
SYSTem:REBoot
This command reboots the instrument, including the operating system.
Usage:
Event
SYSTem:SHUTdown
This command shuts down the instrument.
Usage:
Event
11.13 Emulating Other Instruments' Commands
The R&S FSW analyzer family supports a subset of the GPIB commands of several
HP and PSA instruments.
For details see chapter 10.2, "GPIB Languages", on page 645.
● Setting up Instrument Emulation.........................................................................1049
● Reference: GPIB Commands of Emulated HP Models.......................................1053
● Reference: Command Set of Emulated PSA Models..........................................1081
11.13.1 Setting up Instrument Emulation
The following commands are required to set up the use of commands to emulate other
instruments.
SYSTem:HPCoupling................................................................................................... 1050
SYSTem:IFGain:MODE................................................................................................1050
SYSTem:LANGuage.................................................................................................... 1050
SYSTem:PREamplifier................................................................................................. 1051
SYSTem:PSA:WIDeband..............................................................................................1051
Emulating Other Instruments' Commands