Rohde & Schwarz FSW43 - Performing a Sequence of Measurements

Remote Commands
R&S
®
FSW
687User Manual 1173.9411.02 ─ 19
Parameters:
<ChannelType> Channel type of the new channel.
For a list of available channel types see INSTrument:LIST?
on page 684.
<ChannelName> String containing the name of the channel.
Example:
INST SAN
Activates a measurement channel for the Spectrum application.
INST 'MySpectrum'
Selects the measurement channel named 'MySpectrum' (for
example before executing further commands for that channel).
Usage: SCPI confirmed
Manual operation: See "Spectrum" on page 99
See "1xEV-DO BTS" on page 99
See "1xEV-DO MS" on page 99
See "3G FDD BTS" on page 99
See "3G FDD UE" on page 100
See "Analog Demodulation" on page 100
See "cdma2000 BTS" on page 100
See "cdma2000 MS" on page 100
See "(Multi-Carrier) Group Delay" on page 100
See "GSM" on page 100
See "I/Q Analyzer" on page 101
See "LTE" on page 101
See "Noise Figure" on page 101
See "Phase Noise" on page 101
See "Pulse Measurements" on page 101
See "Realtime Spectrum" on page 101
See "TD-SCDMA BTS" on page 102
See "TD-SCDMA UE" on page 102
See "Transient Analysis" on page 102
See "Vector Signal Analysis (VSA)" on page 102
See "WLAN" on page 102
See "New Channel" on page 105
11.4.2 Performing a Sequence of Measurements
The following commands control the sequencer.
For details on the Sequencer see chapter 4.5.1, "The Sequencer Concept",
on page 105.
INITiate:SEQuencer:ABORt............................................................................................ 688
INITiate:SEQuencer:IMMediate....................................................................................... 688
INITiate:SEQuencer:MODE.............................................................................................688
SYSTem:SEQuencer......................................................................................................689
Selecting the Operating Mode and Application