Rohde & Schwarz FSW43 - Selecting the Operating Mode and Application; Selecting the Mode and Applications

Remote Commands
R&S
®
FSW
682User Manual 1173.9411.02 ─ 19
Triggers selftests of the instrument and returns an error code in decimal form (see Ser-
vice Manual supplied with the instrument). "0" indicates no errors occured.
Usage: Query only
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage:
Event
11.4
Selecting the Operating Mode and Application
The following commands are required to select the operating mode or the application
and to configure a Sequencer in a remote environment. The tasks for manual operation
are described in chapter 4, "Applications and Operating Modes", on page 96.
● Selecting the Mode and Applications....................................................................682
● Performing a Sequence of Measurements............................................................687
● Programming Example: Performing a Sequence of Measurements.....................690
11.4.1 Selecting the Mode and Applications
DISPlay:ATAB............................................................................................................... 682
INSTrument:CREate:DUPLicate...................................................................................... 683
INSTrument:CREate[:NEW]............................................................................................ 683
INSTrument:CREate:REPLace........................................................................................684
INSTrument:DELete....................................................................................................... 684
INSTrument:LIST?......................................................................................................... 684
INSTrument:MODE........................................................................................................ 686
INSTrument:REName.....................................................................................................686
INSTrument[:SELect]......................................................................................................686
DISPlay:ATAB <State>
This command switches between the MultiView tab and the most recently displayed
measurement channel.
Selecting the Operating Mode and Application