Rohde & Schwarz FSW43 - Page 683

Remote Commands
R&S
®
FSW
683User Manual 1173.9411.02 ─ 19
Parameters:
<State> ON | OFF
ON
The MultiView tab is displayed.
OFF
The most recently displayed measurement channel is displayed.
*RST: OFF
INSTrument:CREate:DUPLicate
This command duplicates the currently selected measurement channel, i.e starts a
new measurement channel of the same type and with the identical measurement set-
tings. The name of the new channel is the same as the copied channel, extended by a
consecutive number (e.g. "Spectrum" -> "Spectrum 2").
The channel to be duplicated must be selected first using the INST:SEL command.
This command is not available if the MSRA/MSRT Master channel is selected.
This command is not available if the MSRA Master channel is selected.
Example:
INST:SEL 'Spectrum'
INST:CRE:DUPL
Duplicates the channel named 'Spectrum' and creates a new
measurement channel named 'Spectrum 2'.
Usage: Event
Manual operation: See "Duplicate Current Channel" on page 105
INSTrument:CREate[:NEW] <ChannelType>, <ChannelName>
This command adds an additional measurement channel. The number of measure-
ment channels you can configure at the same time depends on available memory.
See also
● INSTrument[:SELect] on page 686
● INSTrument:DELete on page 684
Parameters:
<ChannelType> Channel type of the new channel.
For a list of available channel types see INSTrument:LIST?
on page 684.
<ChannelName> String containing the name of the channel. The channel name is
displayed as the tab label for the measurement channel.
Note: If the specified name for a new channel already exists, the
default name, extended by a sequential number, is used for the
new channel (see INSTrument:LIST? on page 684).
Example:
INST:CRE SAN, 'Spectrum 2'
Adds an additional spectrum display named "Spectrum 2".
Selecting the Operating Mode and Application