Rohde & Schwarz FSW43 - Calibration and Temperature Checks

Remote Commands
R&S
®
FSW
1022User Manual 1173.9411.02 ─ 19
11.10.2 Calibration and Temperature Checks
The following commands control calibration and temperature checks on the R&S FSW.
CALibration[:ALL]?.......................................................................................................1022
CALibration:RESult?.....................................................................................................1022
DIAGnostic:SERVice:INPut:MC:DISTance......................................................................1023
DIAGnostic:SERVice:INPut:PULSed:CFRequency.......................................................... 1023
DIAGnostic:SERVice:INPut:RF:SPECtrum......................................................................1023
DIAGnostic:SERVice:INPut:AIQ[:TYPE]......................................................................... 1024
DIAGnostic:SERVice:INPut[:SELect]..............................................................................1024
DIAGnostic:SERVice:STESt:RESult?.............................................................................1024
SOURce:TEMPerature:FRONtend?............................................................................... 1025
CALibration[:ALL]?
This command initiates a calibration (self-alignment) routine and queries if calibration
was successful.
During the acquisition of correction data the instrument does not accept any remote
control commands.
In order to recognize when the acquisition of correction data is completed, the MAV bit
in the status byte can be used. If the associated bit is set in the Service Request
Enable (SRE) register, the instrument generates a service request after the acquisition
of correction data has been completed.
Return values:
<CalibrationState> 0
The command returns a '0' if calibration was successful.
Example:
*CLS
Resets the status management.
*SRE 16
Enables MAV bit in the Service Request Enable register.
*CAL?
Starts the correction data recording, and then a service request
is generated.
Usage: Query only
SCPI confirmed
Manual operation: See "Starting a Self-alignment" on page 576
CALibration:RESult?
This command returns the results collected during calibration.
Return values:
<CalibrationData> String containing the calibration data.
Configuring the R&S FSW