Measurements
R&S
®
FSW
299User Manual 1173.9411.02 ─ 19
5.13.4 EMI Measurement Configuration
On the R&S FSW, EMI measurement configuration consists of the following settings,
most of which are accessible from the main EMI menu. This menu is displayed when
you select the EMI measurement and then press the MEAS CONFIG key.
In addition, some common settings are also relevant for EMI measurements:
●
chapter 9.3.2, "Transducer Settings", on page 571
●
chapter 7.5.3.2, "Limit Line Settings and Functions", on page 528
● EMI Marker Configuration..................................................................................... 299
● EMI Final Measurement Configuration..................................................................302
● LISN Control Settings............................................................................................304
5.13.4.1 EMI Marker Configuration
The inital peak search for the R&S FSW EMI measurement is defined by the marker
configuration.
To configure EMI markers select the EMI measurement, then press the MEAS
CONFIG or MKR key and select "Marker Config".
Selected Marker..........................................................................................................299
Marker State................................................................................................................299
Marker Position (X-value)............................................................................................299
Marker Type................................................................................................................300
Reference Marker....................................................................................................... 300
Linking to Another Marker...........................................................................................300
Assigning the Marker to a Trace................................................................................. 300
Final Test Detector......................................................................................................301
Select Marker..............................................................................................................301
Selected Marker
Marker name. The marker which is currently selected for editing is highlighted orange.
Remote command:
Marker selected via suffix <m> in remote commands.
Marker State
Activates or deactivates the marker in the diagram.
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 932
CALCulate<n>:DELTamarker<m>[:STATe] on page 930
Marker Position (X-value)
Defines the position (x-value) of the marker in the diagram.
Remote command:
CALCulate<n>:MARKer<m>:X on page 932
CALCulate<n>:DELTamarker<m>:X on page 931
Electromagnetic Interference (EMI) Measurement (R&S FSW-K54)
To Next Page
Loading...
