Remote Commands
R&S
®
FSW
1086User Manual 1173.9411.02 ─ 19
Parameters:
<State> ON | OFF
OFF
The window is closed.
*RST: OFF
Usage: SCPI confirmed
DISPlay[:WINDow<n>]:TYPE <WindowType>
This command selects the results displayed in a measurement window.
Note that this command is maintained for compatibility reasons only. Use the LAYout
commands for new remote control programs (see chapter 11.6.2, "Working with Win-
dows in the Display", on page 822).
Parameters:
<WindowType> DIAGram
Selects a diagram.
MTABle
Selects a marker table
PEAKlist
Selects a peak list
RSUMmary
Selects a result summary.
SGRam
Selects a spectrogram.
SOURce:EXTernal:FREQuency:SWEep[:STATe] <State>
Note that this command is maintained for compatibility reasons only. It is not required
in new remote control programs.
This command activates or deactivates the frequency sweep for the selected genera-
tor.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
SOUR:EXT:FREQ:SWE ON
Activates the frequency sweep for the external generator.
SYSTem:COMPatible <Mode>
This command enables compatibility to other spectrum and signal analyzers by R&S.
Compatibility is necessary, for example, regarding the number of sweep points.
Commands for Compatibility
To Next Page
Loading...
