Common Measurement Settings
R&S
®
FSW
313User Manual 1173.9411.02 ─ 19
1. "Select Measurement"
See chapter 5.1, "Available Measurement Functions", on page 110
2. Input
See chapter 6.2.2, "Input Source Settings", on page 318
3. Amplitude
See chapter 6.4, "Amplitude and Vertical Axis Configuration", on page 393
4. Frequency
See chapter 6.3, "Frequency and Span Configuration", on page 384
5. (Optionally:) Trigger/Gate
See chapter 6.6, "Trigger and Gate Configuration", on page 418
6. Bandwidth
See chapter 6.5.2, "Bandwidth, Filter and Sweep Settings", on page 408
(For SEM measurements: SEM Setup, see chapter 5.6.5, "SEM Configuration",
on page 208)
(For Spurious measurements: Spurious Setup, see chapter 5.7.4, "Spurious Emis-
sions Measurement Configuration", on page 242)
7. (Optionally:) Outputs
See chapter 6.2.6, "Output Settings", on page 381
8. Analysis
See chapter 7, "Common Analysis and Display Functions", on page 440
9. Display
See chapter 7.1, "Result Display Configuration", on page 440
To configure settings
► Select any button to open the corresponding dialog box.
Preset Channel
Select the "Preset Channel" button in the lower lefthand corner of the "Overview" to
restore all measurement settings in the current channel to their default values.
Note that the PRESET key on the front panel restores the entire instrument to its
default values and thus closes all measurement channels on the R&S FSW (except
for the default Spectrum application channel)!
For details see chapter 8.1, "Restoring the Default Instrument Configuration (Preset)",
on page 538.
Remote command:
SYSTem:PRESet:CHANnel[:EXECute] on page 1005
Configuration Overview
To Next Page
Loading...
