Common Measurement Settings
R&S
®
FSW
323User Manual 1173.9411.02 ─ 19
Using a Power Sensor as an External Power Trigger
Power sensors can be used to trigger a measurement at a specified power level, e.g.
from a signal generator.
Currently, only the following power sensors are supported as power triggers:
●
R&S NRP-Z81
●
R&S NRP-Z85
●
R&S NRP-Z86
With the R&S FSW, the power sensors can be connected to the "Power Sensor" inter-
face directly, and no further cables are required. They can then be configured as an
external power sensor trigger.
Fig. 6-2: Connecting a power sensor using the POWER SENSOR interface
The R&S FSW receives an external trigger signal when the defined trigger level is
measured by the power sensor. Power measurement results are provided as usual.
Data Input and Output
To Next Page
Loading...
