Getting Started
R&S
®
FSW
54User Manual 1173.9411.02 ─ 19
Position O: The entire instrument is disconnected from the AC power supply.
For details refer to chapter 3.1.1.4, "Connecting the AC Power", on page 24.
3.2.2.3 DISPLAY PORT and DVI
You can connect an external monitor or other display device to the R&S FSW to pro-
vide an enlarged display. Two different types of connectors are provided for this pur-
pose:
●
DISPLAY PORT
●
DVI (Digital visual interface)
For details see chapter 3.1.4, "Connecting an External Monitor", on page 31.
3.2.2.4 LAN
The LAN interface can be used to connect the R&S FSW to a local network for remote
control, printouts or data transfer. The assignment of the RJ-45 connector supports
twisted-pair category 5 UTP/STP cables in a star configuration (UTP stands for
unshielded twisted pair, and STP for shielded twisted pair).
For details see chapter 10, "Network and Remote Operation", on page 609.
3.2.2.5 USB
The rear panel provides four additional female USB (USB-A) connectors to connect
devices like a keyboard, a mouse or a memory stick (see also chapter 3.2.1.5, "USB",
on page 46).
Furthermore, a male USB DEVICE connector (USB-B) is provided, for example for a
printer.
All USB connectors support standard 2.0.
3.2.2.6
Bandwidth Extension 160 MHz/ 320 MHz/ 500 MHz with IF WIDE OUTPUT Con-
nector (R&S FSW-B160/-B320/-B500/-U160/-U320)
The signal analysis bandwidth of the R&S FSW can be extended by a hardware option
(R&S FSW-B160/-B320/-B500 or R&S FSW-U160/-U320). The bandwidth extension
allows for a linear bandwidth up to a maximum of 160 MHz (with option B160/U160),
320 MHz (with option B320/U320), or 500 MHz (with option B500), with an output sam-
ple rate of up to 10 GHz. While the extension can be activated or deactivated manually
in the R&S FSW base unit (I/Q Analyzer application), it is activated automatically in
some applications that also support I/Q data analysis. See the application-specific doc-
umentation for details.
Instrument Tour
To Next Page
Loading...
