Getting Started
R&S
®
FSW
63User Manual 1173.9411.02 ─ 19
Fig. 3-8: Adding a new measurement channel
3. Change the frequency range for this spectrum display:
In the "Frequency" dialog box, set the center frequency to 500
MHz and the span
to 1
GHz.
Fig. 3-9: Frequency spectrum of the calibration signal with a larger span
4. Repeat the previous steps to activate a third Spectrum window.
Change the frequency range for this spectrum display:
In the "Frequency" dialog box, set the center frequency to 64
MHz and tap "Zero
Span".
As the calibration signal does not vary over time, the level versus time diagram dis-
plays a straight line.
Trying Out the Instrument
To Next Page
Loading...
