Network and Remote Operation
R&S
®
FSW
660User Manual 1173.9411.02 ─ 19
5. Enter the "IP Address", for example 10.0.0.10. The IP address consists of four
number blocks separated by dots. Every block contains 3 numbers in maximum.
6. Enter the "Subnet Mask", for example 255.255.255.0. The subnet mask consists of
four number blocks separated by dots. Every block contains 3 numbers in maxi-
mum.
7. Close the dialog box.
If you have entered an invalid IP address or subnet mask, the message "out of
range" is displayed in the status line. If the settings are correct, the configuration is
saved, and you are prompted to restart the instrument.
8. Confirm the displayed message ("Yes" button) to restart the instrument.
Using a DNS server to determine the IP address
If a DNS server is configured on the R&S FSW, the server can determine the current
IP address for the connection using the permanent computer name.
1. Obtain the name of your DNS domain and the IP addresses of the DNS and WINS
servers on your network (see chapter 10.5.1.3, "How to Change the Instrument
Name", on page 661).
2. Press the SETUP key and then the "Network + Remote" softkey.
3. In the "Network" tab, select the "Open Dialog 'Network Connections'" button.
4. Double-tap the "Local Area Network" icon.
5. In the "Local Area Connection Status" dialog box, select the "Properties" button.
The items used by the LAN connection are displayed.
6. Tap the entry named "Internet Protocol Version 4 (TCP/IPv4)" to highlight it.
7. Select the "Properties" button.
How to Set Up a Network and Remote Control
To Next Page
Loading...
