Rohde & Schwarz FSW43 - Page 703

Remote Commands
R&S
®
FSW
703User Manual 1173.9411.02 ─ 19
Steep-edged channel filters are available for fast ACLR measurements.
Parameters:
<Bandwidth> Range: 100 Hz to 1000 MHz
*RST: 14 kHz
Manual operation: See "Channel Bandwidths" on page 156
See "Channel Bandwidth" on page 187
See "Channel Bandwidth" on page 192
[SENSe:]POWer:ACHannel:NAME:ACHannel <Name>
This command defines a name for the adjacent channel.
For MSR ACLR measurements, the channel names cannot be defined manually. In
this case, this command is for query only.
Parameters:
<Name> String containing the name of the channel
*RST: ADJ
Manual operation: See "Channel Names" on page 158
[SENSe:]POWer:ACHannel:NAME:ALTernate<ch> <Name>
This command defines a name for an alternate channel.
For MSR ACLR measurements, the channel names cannot be defined manually. In
this case, this command is for query only.
Parameters:
<Name> String containing the name of the channel
*RST: ALT<1...11>
Manual operation: See "Channel Names" on page 158
[SENSe:]POWer:ACHannel:NAME:CHANnel<ch> <Name>
This command defines a name for a transmission channel.
Parameters:
<Name> String containing the name of the channel
*RST: TX<1...12>
Manual operation: See "Channel Names" on page 158
[SENSe:]POWer:ACHannel:SPACing[:ACHannel] <Spacing>
This command defines the distance from transmission channel to adjacent channel.
For MSR signals, this command defines the distance from the CF of the first Tx chan-
nel in the first sub block to the lower adjacent channel, and the distance from the CF of
the last Tx channel in the last sub block to the upper adjacent channel.
Configuring and Performing Measurements