Rohde & Schwarz FSW43 - Page 824

Remote Commands
R&S
®
FSW
824User Manual 1173.9411.02 ─ 19
Example:
LAY:CAT?
Result:
'2',2,'1',1
Two windows are displayed, named '2' (at the top or left), and '1'
(at the bottom or right).
Usage: Query only
LAYout:IDENtify[:WINDow]? <WindowName>
This command queries the index of a particular display window.
Note: to query the name of a particular window, use the LAYout:WINDow<n>:
IDENtify? query.
Query parameters:
<WindowName> String containing the name of a window.
Return values:
<WindowIndex> Index number of the window.
Usage: Query only
LAYout:REMove[:WINDow] <WindowName>
This command removes a window from the display.
Parameters:
<WindowName> String containing the name of the window.
In the default state, the name of the window is its index.
Usage: Event
LAYout:REPLace[:WINDow] <WindowName>,<WindowType>
This command replaces the window type (for example from "Diagram" to "Result Sum-
mary") of an already existing window while keeping its position, index and window
name.
To add a new window, use the LAYout:ADD[:WINDow]? command.
Parameters:
<WindowName> String containing the name of the existing window.
By default, the name of a window is the same as its index. To
determine the name and index of all active windows, use the
LAYout:CATalog[:WINDow]? query.
<WindowType> Type of result display you want to use in the existing window.
See LAYout:ADD[:WINDow]? on page 822 for a list of availa-
ble window types.
Example:
LAY:REPL:WIND '1',MTAB
Replaces the result display in window 1 with a marker table.
Configuring the Result Display