Remote Commands
R&S
®
FSW
867User Manual 1173.9411.02 ─ 19
Parameters:
<Source> RF
Radio Frequency ("RF INPUT" connector)
DIQ
Digital IQ data (only available with optional Digital Baseband
Interface R&S FSW-B17)
For details on I/Q input see the R&S FSW I/Q Analyzer User
Manual.
AIQ
Analog Baseband signal (only available with optional Analog
Baseband Interface R&S FSW-B71)
For details on Analog Baseband input see the R&S FSW I/Q
Analyzer User Manual.
*RST:
RF
Manual operation: See "Radio Frequency State" on page 319
INPut:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S FSW.
See the R&S FSW Getting Started manual for details.
Parameters:
<State> ON | 1
User port is switched to INPut
OFF | 0
User port is switched to OUTPut
*RST: 1
INPut:UPORt[:VALue]?
This command queries the control lines of the user ports.
Example:
INP:UPOR?
Usage: Query only
11.7.6.2 Using External Mixers
The commands required to work with external mixers in a remote environment are
described here. Note that these commands require the R&S FSW-B21 option to be
installed and an external mixer to be connected to the front panel of the R&S FSW. In
MSRA/MSRT mode, external mixers are not supported.
For details on working with external mixers see chapter 6.2.5.1, "Basics on External
Mixers", on page 358.
Setting Basic Measurement Parameters
To Next Page
Loading...
