Rohde & Schwarz NGMO1 - Selecting the Interfaces to be Used

P
o
w
er
S
upp
l
y
NG
M
O
Repair
8.1.1 Selecting the Interfaces to be used
IEEE-488-2 Interface COM Interface:
National NI-488-2 Communicator If the serial interface is used, this
should be manually set to „ON“,
under menu option 31, beforehand.
Apart from that the serial interface
parameters must be adapted to the
parameters of the controlling
computer.
Hyper terminal
All service commands start with the character string:
"rus:service:...".
These are specific for the service and should therefore be treated
confidentially.
The following sections specify the additional commands, which were
implemented in addition to the standard commands.
8-2 3.00 / 05-2014