Rohde & Schwarz NGMO1 - Control I;O Test; Fig. 8-1 Test Set-Up for Control I;O Test

P
o
w
er
S
upp
l
y
NG
M
O
Repair
8.1.8 Control I/O Test
Description The Control I/O test checks the functionality of the signals on the
“Control I/O” plug on the back NGMO. For this purpose the NGMO
calibration adapter must be connected as shown in Fig. 8-1 for the
following test:
Test set-up
Fig. 8-1 Test set-up for Control I/O test
8-10 3.00 / 05-2014