Rohde & Schwarz NGMO1 - Removing of Fans A, B

P
o
w
er
S
upp
l
y
NG
M
O
Remo
v
al
and
Inst
a
ll
a
tion
of
A
s
s
e
mbl
i
es
Rear side (lateral)
4. Unscrew the screws on both sides of the rear wall (17 to 20).
5. Unscrew the screws from CONTROL I/O, IEEE-488-2 and
RS232 (21 to 26).
6. Fold the rear wall carefully down.
7. Take out the processor board
9.1.5 Removing of Fans A, B
1. To remove the fan, disassemble the corresponding analog board
as described in section 9.1.2.
2. Unscrew the screws for the corresponding fan.
3. Pull the fan up to remove.
9-6 3.00 / 05-2014