Rohde & Schwarz NGMO1 - Software Update; Components List; Running the Update

S
oft
w
a
r
e
Update
P
o
w
er
S
upp
l
y
NG
M
O
12 Software Update
12.1 Components List
The following components are needed to update the NGMO firmware:
Pos.
No.
Components Part
number
1 Computer with Windows 95/98/NT/2000/XP/
Vista/7
-
2 9-pole serial 1:1 connecting cable
(extension lead)
(no null-modem cable)
-
3 Power Supply NGMO (Version x)
(Rohde & Schwarz)
-
4 Update file: NGMO_xxx.ZIP -
12.2 Running the Update
Perform the following procedures:
1. Switch on and boot the computer.
2. Copy NGMO_xxx.ZIP into its own directory.
3. Unpack NGMO2_xxx.ZIP using WINZIP or a similar program.
4. Press the two DIP switches on the rear side of the Power Supply
NGMO (see photo left) carefully down with a flat screwdriver.
5. Use the 9-pole serial connecting cable to connect the serial
(COM) interface of the computer to the RS232-interface of the
Power Supply NGMO.
6. Switch on the Power Supply NGMO.
The unit may not respond with a switch-on message at this point.
This is OK.
3.00 / 05-2014 12-1