Rohde & Schwarz NGMO1 - Removal and Installation of Assemblies

Remo
v
al
and
Inst
a
ll
a
tion
of
A
s
s
e
m
b
l
i
es
P
o
w
er
S
upp
l
y
NG
M
O
9 Removal and Installation of
Assemblies
ELECTROCUTION HAZARDS!
Disconnect the unit from the mains supply before opening the
housing.
NOTE:
The following sections describe the procedures for removing
and installing assemblies using the Power Supply NGMO2 as an
example. This version is equipped with two analog boards
(Channel A and Channel B).
The instructions for removal and installation apply also for the
NGMO1, in which case the removal and installation process is
reduced to analog board Channel A. All descriptions and
specifications concerning channel B must be ignored.
3.00 / 05-2014 9-1