Rohde & Schwarz NGMO1 - Installation of Assemblies; Installation of the Analog Boards Y101, Y102; Analog Board Y101 (Channel A); Analog Board Y102 (Channel B)

Remo
v
al
and
Inst
a
ll
a
tion
of
A
s
s
e
m
b
l
i
es
P
o
w
er
S
upp
l
y
NG
M
O
9.2 Installation of Assemblies
9.2.1 Installation of the Analog Boards Y101, Y102
For installation of the analog boards please refer to the illustrations in
section 9.1.2.
9.2.1.1 Analog board Y101 (Channel A)
1. Carefully insert the board into the connection on the processor
board.
2. Press the board slightly down at the points marked “A“ and locate
it with the four lateral screws (14, 15, 18, 20).
3. Fasten the board with the remaining screws (12 to 21).
4. Connect plug X501 (22) for fan A.
9.2.1.2 Analog board Y102 (Channel B)
1. Carefully insert the board into the connection on the processor
board.
2. Press the board slightly down at the points marked “B“ and locate
it with the four lateral screws (3, 4, 7, 8).
3. Fasten the board with the remaining screws (1 to 10).
4. Connect plug X501 (11) for fan B.
9.2.2 Installation of the Keyboard Y202
For installation of the keyboard please refer to the illustrations in sec-
tion 9.1.3.
1. Insert the keyboard into the front panel
2. Turn in screws (8, 9, 10, 11).
3. Connect plugs X101, X102 and X103 (5, 6, 7) to the board.
4. Fasten the front panel to the frame using screws (1, 2, 3, 4).
3.00 / 05-2014 9-7