Function test
• Switch on test 4 with the following remote command:
rus:service:select:function:test 4
• The display shows the following message:
Control I/O test
OK!
• Interrogate test 4:
rus:service:select:function:test?
If no error is present, the returned value of the function should be
0.
Function test The following bits are set when:
Slave I/O fault channel B Bit 9
Slave I/O fault channel A Bit 8
Relay4/TRIGG_A fault Bit 3
Relay3/INHIB_A fault Bit 2
Relay2/TRIGG_B fault Bit 1
Relay1/INHIB_B fault Bit 0
Fault rectification
• In case of an occurring fault:
• replace the processor board as described in chapter 9.
3.00 / 05-2014 8-11
To Next Page
Loading...
