7.3 Calibration Procedure 7-3
7.4 The Calibration Entry ID got lost 7-10
8 Repair 8-1
8.1 Function Tests by using the Service Functions 8-1
8.1.1
Selecting the Interfaces to be used 8-2
8.1.2
Setting the Electronic Serial Number 8-3
8.1.3
Setting the NGMO Device Name (from firmware version 1.10) 8-4
8.1.4
Communication Test with Analog Boards 8-5
8.1.4.1
Commands for channel: A 8-5
8.1.4.2
Commands for channel: B 8-5
8.1.5
Display Blank Test 8-6
8.1.6
Display Unblank Test 8-7
8.1.7
Keyboard and Knob Test 8-8
8.1.8
Control I/O Test 8-10
8.1.9
INHIBIT ON 8-12
8.1.10
Switching off Test Functions 8-14
8.2 Error Messages in the Display 8-15
8.3 Checking the Output Voltages 8-16
8.3.1
Processor Board 8-16
8.3.2
Analog Boards 8-17
8.4 General Troubleshooting 8-18
9 Removal and Installation of Assemblies 9-1
9.1 Removal of Assemblies 9-2
9.1.1
Removing the Housing 9-2
9.1.2
Removing of the Analog Board Y101, Y102 9-3
9.1.2.1
Analog board Y101 (Channel A) 9-3
9.1.2.2
Analog board Y102 (Channel B) 9-3
9.1.3
Removing of Keyboard Y202 9-4
9.1.4
Removing of Processor Board Y301 9-5
9.1.5
Removing of Fans A, B 9-6
9.2 Installation of Assemblies 9-7
9.2.1
Installation of the Analog Boards Y101, Y102 9-7
9.2.1.1
Analog board Y101 (Channel A) 9-7
9.2.1.2
Analog board Y102 (Channel B) 9-7
9.2.2
Installation of the Keyboard Y202 9-7
9.2.3
Installation of Processor Board Y301 9-8
9.2.4
Installation of Fans A, B 9-8
9.2.5
Assembling the Unit 9-8
10 Interfaces 10-1
2 3.00 / 05-2014
To Next Page
Loading...
