Rohde & Schwarz R&S TSME6 - Mounting the Product in a Rack

Getting started
R&S
®
TSME6
13User Manual 4900.0033.02 ─ 08
b) Place the R&S TSME6 on top.
3.1.2.2 Mounting the product in a rack
To mount the product in a rack
1. Use an adapter kit to prepare the product for rack mounting.
a) Order the rack adapter kit designed for the product. For the order number, see
specifications document.
b) Mount the adapter kit. Follow the assembly instructions provided with the
adapter kit.
2. Lift the product to shelf height. If the rack is high, use a safe climbing aid when
placing on upper shelves.
3. Grip the product by the handles. Slide the product onto the shelf until the rack
brackets fit closely to the rack.
4. Tighten all screws on the rack brackets with a tightening torque of 1.2 Nm to
secure the product in the rack.
Rackmounting
The R&S TSME6 can be installed in a 19-inch rack using a rack adapter kit for one to
four R&S TSME6s (option R&S TSME6-Z2, order number 4900.1030.02). The installa-
tion instructions are part of the adapter kit.
Figure 3-1: Rackmounting of 2 R&S
TSME6s
Preparing for use