Rohde & Schwarz R&S TSME6 - Connecting to an AC Power Supply; Putting into Operation

Getting started
R&S
®
TSME6
16User Manual 4900.0033.02 ─ 08
Figure 3-5: Supplied power cable with cigarette lighter adapter
+12 V DC = red/orange cabling
GND = black/brown cabling
3.1.4.3 Connecting to an AC power supply
If you operate the product with an external power supply, you can use it indoors only in
pollution degree 2 environments where nonconductive contamination can occur. Suita-
ble AC power supplies are listed in the specifications document. They differ in the out-
put power:
●
R&S TSMA6-Z1 has an output power of 105 W and is suitable for multiple R&S
TSMx products.
1. Ensure that the required ratings listed in the specifications document are matched.
2. Connect the round connector to DC IN.
3. Insert the AC power plug into a power outlet with ground contact.
3.1.5 Putting into operation
This section describes the basic steps to be taken when setting up the R&S TSME6 for
the first time.
Preparing for use